HOW TO INSTALL - Single Knob Application
Step 1 Remove the loose knob |  |
Step 2 Wrap a 1/2" diameter drill bit with masking tape. Locate the edge of the tape 1/2" from the end of the drill bit as a depth stop. |  |
Step 3 Open the hole in the back panel of the door using the 1/2" drill bit. Be careful to only drill to the depth of the masking tape marker. Be sure to use safety glasses when operating the drill motor. |  |
Step 4 Insert the nylon spacer through the hole in the back panel of the door. Insert the bolt through the busing and the hole in the front panel of the door. |  |
Step 5 Reattach the door knob and tighten the bolt with a screwdriver. |
|
BUY NOW Have a question? Contact us
Alternate Door Handle Applications:
If you have chosen to use a "Dummy Lever Knob" or similar application where more than one bolt is required to fasten the knob/lever, see examples below.
 |  |
The installation process will require; 1) Locate and mark the 2 or 3 bolt hole locations on the front panel, 2) Using a 11/64" drill bit, drill a hole through both front and back door panels at each bolt location, 3) Follow steps 2, 3 & 4 above to open the hole up in the back panel and to insert the Knob Secure spacer, 4) If using a dummy lever knob use through bolts (Flat Head 8x32, 1 1/2" or 1 3/4"), inserting them from the front to the back and installing a metal washer and nut on the back side of the door, 5) If necessary, cut off the excess bolt length with a hacksaw and file the end of the bolt smooth.
Associated with BBB since 2008